Specifications

CVP-109/107/105/103/700

CAttach the rear panel (B).

With the rear panel slightly angled as shown in the illus-

tration, lower it onto the feet’s protruding edge at the rear

of the pedal box. Then, while eliminating any gaps be-

tween the rear and side panels, secure the top of the rear

panel to the side panel brackets using two 4 x 12 mm

round-head screws 2. Finally, secure the bottom of the

rear panel to the pedal box using four 4 x 20 mm tapping

screws 3.

VInstall the main unit (A).

Place the main unit (A) on the side panels (D) with the

screws on its bottom panel (toward the rear of the main

unit) just behind the grooves in the brackets located at the

top of the side panels. Then slide the main unit forward

until it stops. WATCH YOUR FINGERS WHEN DO-

ING THIS!!

Align the holes on the bottom panel of the main unit with

the holes in the brackets on the side panels (also center

the main unit to produce equal clearance on the left and

right sides, as shown in the illustration), then screw in and

securely tighten the four 6 x 16 millimeter flat-head

screws 4.

CAUTION

• Do not hold the keyboard in any position other than the position

shown in the above illustration.

• Fingers can become pinched between the main unit and the rear or

side panels, be extra careful so as not to drop the main unit.

• 4 x 20 mm tapping screws 3

• 4 x 12 mm round-head screws 2

• Be sure to place your hands

at least 15 centimeters from

either end of the main unit when

positioning it.

15 cm