Specifications

CVP-109/107/105/103/700

• Blanket, etc.

2 3

• 5 x 12 mm large screws x 30

• AC power cord

• 4 x 12 mm small screws x 4

• Left leg

• Right leg

XCarefully lean the main unit against a wall.

To make it easier to install the legs, place a soft blanket or simi-

lar material on the floor near a wall, close the Clavinova key-

board cover, place the

front panel of the Clavinova (the side

with the keyboard) on the blanket and gently lean the unit

against the wall — MAKING SURE THAT IT CAN NOT

FALL — as shown in the illustration.

CAUTION

• Do not lay the main unit upside-down on the floor.

C Pedal assembly.

A: Under the pedal box, remove the vinyl tie from the pedal

cable (the illustration shows the tie removed). Paying close

attention to the direction of the rear legs (take note of the leg

brackets in the illustration), slide the pedal box onto the left leg.

B: Align the cut hole in the pedal box with the hole in the left

leg and insert the cable into the hole on the left leg, pull the

cable out of the top of the left leg.

C: Align the screw holes, attach the two 4 x 12 millimeter small

screws to 2 locations. (First tighten both screws loosely, once the

position has been determined tighten firmly.)

Use the same procedure (A, B and C) to attach the right

leg.(However, the right leg is not equipped with a pedal cord.)

CAUTION

• When you lift the pedal box assembly, make sure that you lift by

both legs.