User Manual

MONTAGE Owner’s Manual
14
Power Supply
Connect the supplied AC power cord in the following order.
Make sure the [STANDBY/ON] switch on the instrument is set
to the Standby position.
1 Connect the supplied power cord to the AC IN
on the instrument’s rear panel.
2 Connect the other end of the power cord to
an AC outlet.
NOTE
Follow this procedure in reverse order when disconnecting the power
cord.
WARNING
• Use only the AC power cord supplied with your instrument.
The use of an inappropriate replacement can lead to
overheating or electric shock.
• The power cord supplied with your instrument must not be
used with other electrical equipment. Failure to observe this
precaution can result in the equipment being damaged or
cause a fire.
• Make sure your instrument the voltage requirement for the
country or region in which it is being used.
CAUTION
The instrument remains charged and draws a small amount of
power even when the [STANDBY/ON] switch is set to the Standby
position. If you intend not to use it for an extended period of
time, therefore, make sure to unplug the power cord from the
wall outlet.
Connecting Speakers or
Headphones
Since the instrument has no built-in speakers, you will need
to monitor the sound of the instrument by using external
equipment. Connect a set of headphones, powered
speakers, or other playback equipment as illustrated below.
When making connections, be sure that your cables have
the appropriate ratings.
Powering Up the System
Make sure the volume settings of the instrument and external
devices such as powered speakers are turned to the
minimum before turning the power on. When connecting the
instrument to powered speakers, turn on the power switch of
each device in the following order.
When turning the power on:
First, the instrument (the display will turn on and the buttons
will light), then the connected powered speakers.
When turning the power off:
First, the connected powered speakers, then the instrument
(the display will turn off and the buttons will turn off).
Keep in mind that the [STANDBY/ON] switch is located at the
right side (from the view of the keyboard) of the AC IN socket
on the rear panel of the instrument.
Setting Up
Rear panel
AC IN
Power cord (included)
Powered speaker
(left)
Powered speaker
(right)
Headphones
OUTPUT L/MONO OUTPUT R
PHONES
AC IN
[STANDBY/ON]
switch