Service manual

V-BELT, CLUTCH AND
SECONDARY/PRIMARY SHEAVE
I ENG I{ =l
3. Loosen:
• Nut(Clutch carrier)(~
NOTE:
Install the secondary sheave to primary drive
shaft as shown, and hold the secondary sheave
by Universal Roter Holder(~to loosen the nut
(#.
~ Roter holding tool" ]
YU-01235
CAUTION:
Do not remove the clutch securing nut yet.
If the nut is removed without compressiong
the secondary sheave. It jumps and causes in-
jury.
4. Attach:
• Clutch spring holder (~
I<~l CI utch spring holder:ys_28891
5. Remove:
• Clutch securing nut (~)
6. Remove:
• Clutch assembly (~
• Clutch spring (~
• Spring seat (~
• Guide pins
• Secondary sliding sheave
CLUTCH INSPECTION
1. Inspect:
• Clutch shoes
Glazed parts-->Sand with coarse sand-
paper.
NOTE:
After using the sand paper, clean of the pol-
ished particles with cloth.
4-17