Service manual

,.o°T B.AKE Ic"AsI ol
/
i
/
I
t
4. Install:
• Pad springs
• Brake pads (new)
Installation steps:
• Connect a suitable hose (~ tightly to the cali-
per bleed screw (~. Then, place the other end
of this hose into an open container.
• Loosen the caliper bleed screw and push the
piston (~ into the caliper by your finger.
• Tighten the capliper bleed screw.
H ~ ~ (0.~ ~.k~, 4.3 ~.'~ i
• Install the pad spring (new) and brake pad
(new) (~
• Tighten retaining bolt (~
~123 Nm (2.3 m.kg, 16.6 ft.lb) I
• Install brake hose holder (~
l~l 7 Nm (0.7 m.k~, 5.15 ft.lb) I
• Install caliper (~ [~23 Nm (2.3 m.kg, 16.6 ft.ib) I
5. Inspect:
• Brake fluid level
Refer to the "BRAKE FLUID INSPEC-
TION" section in the CHAPTER 3.
(~ "LOWER" level line
6-10