Service manual

2-15
SPEC
TIGHTENING TORQUES
1 Lower ring nut
2 Rubber washer
3 Center ring nut
4 Lock washer
5 Upper ring nut
NOTE :
1. First, tighten the ring nut(lower) approximately 38Nm(3.8m•kg, 27.5ft•lb) by using the torque
wrench, then loosen the ring nut 1/4 turn.
2. Second, tighten the ring nut(lower) approximately 12Nm(1.2m•kg, 8.7ft•lb) by using the torque
wrench.
3. Installing the rubber washer.
4. Then finger tighten the center ring nut and touch rubber washer. Align the slots both ring nut and
install the lock washer.
5. Final, hold the ring nuts(lower and center) and tighten the ring nut(upper) 75Nm(7.5m•kg, 54.2ft•lb)
by using the torque wrench.
6. Confirm, adjust the direction handlebar to the right direction, front wheel suspended. Push di-
rection handlebar lightly with the finger (approximately 1.5kgf • cm), direction handlebar should
turn slowly without interference or hindrance.