Service manual

MA...E°A.OE SPEO.F.OA -.O° ISPEcl I
MAINTENANCE SPECIFICATION
ENGINE
Cylinder head:
Warp limit "~
Item Sta nda rd Limit
*Lines indicate straightedge measurement
Cylinder:
Bore size
Taper limit
40.000~40.014mm
(1.5748~1.5754 in)
Out of round Ih-nit
Piston:
Piston to cylinder clearance
Piston size "D"
Measuring point "H"
Piston pin bore inside diameter
Piston pin outside diameter
Piston Ring:
Sectional Sketch (B × T)/'l-ype
Top Ring
2nd Ring
End Gap (Installed):
Top Ring
2nd Ring
Side Clearance ( Installed):
Top Ring
2nd Ring
I~ Yl
0.035~0.040 mm
(0.0014~0.0016 in)
39.958~39.972 mm
(1.5731~1.5737 in)
5 mm(O.2 in)
10.004~10.015 mm
(0.3939~0.3943 in)
9.996~10.000 rnrn
(0.3935~0.3937 in)
1.2 × 1.6 mm/keystone
(0.05 × 0.06 in)
1.2 × 1.6 ram/keystone
(0.05 × 0.06 in)
0.15~0.35 mm
(0.005~0.01 in)
0.15~0.35 mm
(0.005~0.01 in)
0.03~0.05 mm
(0.0012~0.0020 in)
0.03~0.05 mm
(0.0012~0.0020 in)
0.03 mm
(0.0012 in)
40.10 mm
(1.5787 in)
0.05 mm
(0.0020 in)
0.03 rnm
(0.0012 in)
0.10 mm
(0.0039 in)
10.045 mm
(0.4 in)
9.975 mm
(0.39 in)
0.6 mm(O.02 in)
0.6 mm(O.02 in)
0.1 mm(O.O039 in)
0.1 mm(O.O039 in)
2-4