Service manual
6-15
JET
PUMP
Jet pump unit
TIP:
• Remove any adhesive that is protruding in
or around the hole for the intermediate
drive shaft.
• After installing the joint, allow the adhesive
to harden for at least 24 hours before plac-
ing the watercraft in the water.
Driven coupling removal and
installation
1. Remove the driven coupling.
TIP:
• Install the driven coupling using the same
special service tools that were used for
removal.
• Check that the drive shaft holder and inter-
mediate drive shaft are properly engaged.
Intermediate drive shaft extension
removal
1. Remove the intermediate drive shaft
extension.
TIP:
• Fit a wrench into the notches in the inter-
mediate drive shaft extension.
• Check that the drive shaft holder and inter-
mediate drive shaft are properly engaged.
Intermediate drive shaft removal
1. Remove the intermediate drive shaft.
TIP:
Remove the intermediate drive shaft using a
press.
Bearing removal
1. Remove the circlip, bearing and oil seals.
Coupler wrench: 90890-06425
Drive shaft holder 5: 90890-06519
Width a: 27 mm (1.06 in)
a
a
Drive shaft holder 5: 90890-06519
Width a: 27 mm (1.06 in)