Service manual

HULL
HOOD
Hull and hood
8-15
Shift lever assy. check
1. Check the shift lever assy. Replace if
cracked or damaged. NOTICE: Do not
disassemble the shift lever assy.
Bushing check
1. Check the bushing. Replace if cracked,
damaged, or worn.
Steering arm assy. installation
1. Install the steering arm assy. 1, nut 2
and plate 3, and then tighten the bolt 4
to the specified torque.
TIP:
• Align the projection on the steering shaft
assy. with the slot on the arm.
• Align the tab a on the plate 3 with the por-
tion b on the steering arm assy. 1.
• Bend a tab c along a flat side of the bolt.
Steering arm assy. bolt 4:
16 N·m (1.6 kgf·m, 11.8 ft·lb)
3
2
1
4
a
c
b