Owner`s manual

ma I n t e n a n c e & ca r e
4
4-14
Replacement Procedure
When the anode has eroded to
approximately one-half its original size,
it should be replaced. Ask your dealer
for this service or you can do it your-
self if you have a torque wrench of the
proper type.
1) Unscrew the two mounting bolts
that secure the anode to the jet
pump outlet.
2) Clean the mounting-bolts threads,
then coat them with Loctite
®
242,
available from your Yamaha dealer.
3) Install the new anode. Tighten the
mounting bolts to specification.
FUSE REPLACEMENT
Do not use fuses of higher am-
perage that those recommended.
Substitution of a fuse of improper
rating can cause extensive electrical
system damage and possible fire.
The fuse is in the ignition coil holder.
To replace the fuse, unscrew the cap
and pull the two red leads out with the
fuse holder. Open the fuse holder and
replace the fuse.
 Ignition coil holder
 Cap
 Fuse(10A)
 Fuseholder
Accessory Fuses
 Main Accessory power, Yellow, 20 amp
 Shower pump, Pink, 4 amp
Anode Bolt Torque:
50~80 kgf-cm (47~70 inch-pounds)
WARNING

WARNING




