Owner`s manual

op e r a t I o n
3
3-11
Cooling-Water Pilot Outlets
Check that water comes out from the
pilot outlets while engine is running
in the water. Refer to page 2-13 for
correct operation of the device.
NOTE: It may take up to 20 seconds
for water to reach the pilot outlets when
first launching the boat. The amount
and force of the exiting water will vary
with engine rpm.
A continuous flow of water from the
pilot hole shows that water is flow-
ing through the engine cooling pas-
sages. If water is not flowing out of
the pilot hole during operation, do
not continue to run the engines.
Overheating and serious damage
could occur. See Engine Overheat
Warning System, page 2-13, for more
information.
Bimini Top SX240 and 242 Limited
Raising from the Collapsed Position:
1) Unzip and remove the storage cover.
2) Unfold the top by pulling it to
the back of the boat (toward the
stern).
3) Attach the snap hooks to the strap
eyes.
4) The top should be snug and wrin-
kle free. If the top is too loose, or
too tight, adjust the rear straps by
sliding the buckle up or down the
strap as needed.
Do not exceed 45 mph (72 km/h)
with the Bimini top in the deployed
position.
NOTICE:
NOTICE: