Owner`s manual

ma I n t e n a n c e & ca r e
4
4-8
4) Wipe off any water on the spark plug
or inside the spark plug cap, and
then install the cap. Push the spark
plug cap down until it is securely
installed and install the spark plug
cap screws.
TIP:
If a torque wrench is not available
when you are installing a spark plug,
a good estimate of the correct torque
is 1/4 turn to 1/2 turn past finger tight
using the spark plug wrench included
in the tool kit. Have the spark plug
adjusted to the correct torque with a
torque wrench as soon as possible.
5) Install the engine cover and engine
cover screws.
GREASE POINTS
To keep moving parts sliding or rotating
smoothly, coat them with water resistant
grease such as Yamaha Marine Grease,
Yamaha Grease A, or an equivalent.
Throttle Cable
Grease the throttle-cable inner wires at
the pulley wheel of the APS.
Steering Cable Ball Joints and
Inner Wire
Grease the steering cable and shift
cables ball joints at the steering noz-
zles. Extend the steering cable and
shift cable inner wires and apply a thin
coat of grease to them.
Pivot Points
Grease all pivot points of the steering
and shift mechanism at the pump end.