User Manual

Before Using the P-140
P-140 Owner’s Manual
ENGLISH
12
Before Using the P-140
Turning the Power On
1.
Connect the PA-5D power adaptor’s DC
cable to the [DC IN 12V] jack.
2.
Plug the AC adaptor into an AC outlet.
WARNING
Use ONLY a Yamaha PA-5D AC Power Adaptor (or other adaptor spe-
cifically recommended by Yamaha) to power your instrument from
the AC mains. The use of other adaptors may result in irreparable
damage to both the adaptor and the P-140.
CAUTION
Unplug the AC Power Adaptor when not using the P-140, or during
electrical storms.
3.
Press the [STANDBY/ON] switch to turn
the power on.
The display located in the center of the front panel lights up.
When you’re ready to turn off the power, press the
[STANDBY/
ON]
switch again.
CAUTION
Even when the instrument is turned off, electricity is still flowing to
the instrument at the minimum level. When you are not using the P-
140 for a long time, make sure you unplug the AC power adaptor
from the wall AC outlet.
When turning off the power, press and hold down the
[STANDBY/ON] switch for a short time until the power turns
off. The P-140 uses this power-off procedure as a “safety” device
to prevent the power from being inadvertently turned off during
performance.
Setting the Volume
Initially set the
[MASTER VOLUME]
slider about halfway between the “MIN” and “MAX” settings. Then, when you start
playing, re-adjust the
[MASTER VOLUME]
slider to the most comfortable listening level.
TERMINOLOGY
MASTER VOLUME:
The volume level of the entire keyboard sound
(The shape of plug differs
depending on locale.)
Display
Normally indicates tempo.
The level increases.The level decreases.