User Manual

CVP-601 Owner’s Manual

Assembly

2 Attach B.

1 Align the screw holes on the upper side of B with

the bracket holes on D and E, then attach the

upper corners of B to D and E by finger-

tightening two thin screws (4 x 12 mm).

2 Secure the bottom end of B using four tapping

screws (4 x 20 mm).

3 Securely tighten the screws on the top of B that

were attached in step 2-

3 Mount A.

Be sure to place your hands at least 15cm from

either end of the main unit when positioning it.

4 Secure A.

1 Adjust the position of A so that the left and right

ends of A will project beyond D and E equally (as

seen from the front).

2 Secure A by tightening six short screws (6 x 16

mm) from the front.

5 Connect the pedal cord and power cord.

1 Insert the plug of the pedal cord into the pedal

connector.

2 Attach the cord holders to the rear panel as

shown, then clip the cord into the holders.

3 Use a vinyl tie to take up any slack in the pedal

cord.

4 Insert the plug of the power cord into the power

connector.

CAUTION

• Be extra careful not to drop or let your fingers be

pinched by the main unit.

• Do not hold the main unit in any position other than the

position specified.

Align the screw holes

15cm or further in

Insert the pedal cord securely

until the metal part of the cord

plug disappears from view.

Otherwise, the pedal may not

function properly.