Service manual

RX-V363/HTR-6130
19
RX-V363/HTR-6130
13.PRESET INHI 13.PRESET RSRV
* When the version of the firmware to be written is the same as the one existing in this unit, “Same Version”,
“Please...” and “Turn off!!” are displayed repeatedly. (Upgrading is not necessary.)
If the display remains unchanged for more than 10 seconds after starting the firmware CD play procedure, per-
form the firmware CD play procedure again from the beginning.
If “FILE CORRUPTED” is displayed after “Address:XXXXXX”, make sure that the firmware CD is not corrupted
and perform steps 1 to 8 of “Operation Procedures” again.
If “Upgrade Failed” is displayed, perform Steps 1 to 8 of “Operation Procedures” again.
9. Press the “STOP” key of the DVD/CD player.
10. Press the “EJECT” key of the DVD/CD player to open the disc tray.
11. Remove the firmware CD from the disc tray and close the disc tray.
12. Turn off the power of the DVD/CD player and disconnect the power cable from the AC outlet.
13. Turn off the power by pressing the “STANDBY/ON” key of this unit.
● Confirmation of firmware version and checksum
To confirm that the firmware is updated successfully, check the firmware version and checksum value by using the self-
diagnostic function menu “14. ROM VER/SUM”.
For more information, refer to “SELF DIAGNOSTIC FUNCTION”.
* When the displayed firmware version and checksum are different from written firmware version and checksum, follow
the steps from 1 to 13 of “Operation Procedures” again.
● Initializing of this unit
* After updating the firmware, be sure to initialize this unit.
1. Connect the power cable of this unit to the AC outlet.
2. Press the “STANDBY/ON” key while simultaneously pressing the “STRAIGHT” and “AUDIO SELECT” keys. (Fig. 5)
The self-diagnostic function is activated.
3. Select the main menu “13. FACTORY PRESET”.
4. Select the “PRESET RSRV”.
PRESET RESERVED (Initialization reserved)PRESET INHIBIT (Initialization inhibited)
5. Turn off the power of this unit and disconnect the power cable from the AC outlet.