Installation manual

10
If you first switch on the PSR9000/9000Pro, with a USB cable connected to
your computer, and then turn on the computer, this may create conflict with
your computer’s Auto Load function, depending upon the type of hard disk
installed. To avoid such potential problems, it would be good practice to
connect the USB cable after Auto Load has been completed, or at least be
sure that the 9000 is turned off before the computer is turned on.
NOTE: PSR 9000 operating system Version 3.0 and 9000 Pro Version 2.0
introduced a parameter to set hard disk sleep time mode. On the same Utility
“Time” page where you deactivated the screen saver, the third button from
the top, to the left of the LCD screen, brings up setting options for “HD
Sleep Time”. The factory default setting is 30 seconds. Be sure that it is
not set to “Never”, or the USB Interface cannot be recognized.
Information about the PSR9000/9000Pro File System
Don’t use any special characters such as Ö, Å, ć etc for file names. Also, in most
PSR9000/9000Pro menus, only 10 characters are displayed, and you cannot store
more than 250 files in one folder.
Important settings for Removable Device (Win 98 and Win ME)
Open “Settings” > “Control Panel” Æ “System” Æ “Device Manager” >”View Devices
by Type”, and expand “Disk drives” by clicking its “+” sign.
Select your 9000 hard disk’s designation and click on the “Properties” button.
Select “Settings” and check the “Removable Device” box. To activate the new
setting, you must restart your computer. The PSR9000/9000PRO’s hard disk will
subsequently be displayed as removable device(s), depending upon the number of
partitions to which letters were assigned.
Refresh the Computer Display
If you have stored data from the PSR-9000 on the PSR-9000 hard disk drive, the
new content is displayed after you selected View/Refresh. If you need this
function, you must change the following setting: Open the Control Panel, select
System/Device Manager and then Disk drives. Choose your PSR-9000’s hard disk
and then the “Settings” tab. Now select removable device, click “OK”, and restart
your Computer. All PSR-9000 partitions are now “Removable Devices”