Installation manual

Simm cover

USB connector position

(See illustration above.) The best mounting position is on the angled surface along

the left edge of the cover, looking at it as above (circled area). There must be

adequate clearance between the socket and any mounted optional SIMMs. This

should be no problem.

Drill three holes in the metal cover, marking locations by printing the following

illustration and using it as a template:

Carefully mark and drill all three holes with a 3mm (or 1/8 inch) drill bit. Then

enlarge the middle hole to 10mm (13/32 inch) diameter. Using appropriate screws

and nuts, attach the USB socket to the metal cover and reinstall it on the

9000PRO.