Owner`s manual

Operation
34
● Check fuel line connections to be sure they
are tight (if equipped Yamaha fuel tank or
boat tank).
● Be sure the fuel tank is positioned on a se-
cure, flat surface, and that the fuel line is not
twisted or flattened, or likely to contact
sharp objects (if equipped Yamaha fuel
tank or boat tank).
● Check the water in the fuel filter with the wa-
ter separator warning device. Place the
gear shift lever in neutral and turn the main
switch to “”(on). If the buzzer sounds and
the water separator warning indicator
blinks, consult your Yamaha dealer imme-
diately.
EMU27130
Controls
● Check throttle, shift, and steering for proper
operation before starting the engine.
● The controls should work smoothly, without
binding or unusual free play.
● Look for loose or damaged connections.
● Check operation of the starter and stop
switches when the outboard motor is in the
water.
EMU27150
Engine
● Check the engine and engine mounting.
● Look for loose or damaged fasteners.
● Check the propeller for damage.
● Check that the battery is in good condition
and the battery connections are secure.
EMU27163
Checking the engine oil level
1. Put the outboard motor in an upright po-
sition (not tilted).
2. Remove oil dipstick and wipe it clean.
3. Completely insert the dipstick and re-
move it again.
4. Check the oil level using the dipstick to be
sure the level falls between the upper and
lower marks. Fill with oil if it is below the
lower mark, or drain to the specified level
if it is above the upper mark.
NOTE:
Be sure to completely insert the dipstick into
the dipstick guide.
EMU30021
Filling fuel
WARNING
EWM00060
Gasoline and its vapors are highly flam-
mable and explosive. Keep away from
sparks, cigarettes, flames, or other sourc-
es of ignition.
1. Oil dipstick
1. Lower level mark
2. Oil dipstick
3. Upper level mark
ZMU04257
1
U6D613E0.book Page 34 Thursday, March 2, 2006 11:28 AM