Owner's Manual

29 En
Problem Cause Remedy
See
page
A “humming” sound
is heard.
Incorrect cable connections. Connect the audio cable plugs firmly. If the problem
persists, the cables may be defective.
16
No connection from the turntable to the
GND terminal.
Connect the turntable to the GND terminal of this
unit.
16
The sound is
degraded when
listening with the
headphones
connected to the CD
player connected to
this unit.
The power of this unit is turned off. Turn on the power of this unit.
—
The volume level is
low while playing a
record.
Incorrect setting for the MM/MC switch
on the rear panel.
Switch the MM/MC switch to the MM or MC
position according to the type of magnetic cartridge
of the turntable.
10
The remote control
does not work or
function properly.
Wrong distance or angle. The remote control functions within a maximum
range of 6 m (20 ft) and no more than 30 degrees off-
axis from the front panel.
14
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
Reposition this unit.
8
The batteries are weak. Replace all batteries.
14
Taking care of this unit
Polish finish on the side panels
Use of a piano cleaning cloth is recommended.
For heavy dirt, use a soft cloth that has been dampened
and wrung out thoroughly.
Other finish
When you wipe this unit, do not use chemical solvents
(alcohol, thinner, etc.), which might damage the finish.
Use a clean, dry cloth. For heavy dirt, dampen a soft
cloth in detergent diluted with water, wring it out, and
clean this unit with the cloth.
English