U Integrated Amplifier Amplificateur Intégré OWNER’S MANUAL MODE D’EMPLOI
IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
IMPORTANT SAFETY INSTRUCTIONS FCC INFORMATION (for US customers) 1 IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product. 2 IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded cables. Cable/s supplied with this product MUST be used.
CAUTION: READ THIS BEFORE OPERATING YOUR UNIT. CAUTION: READ THIS BEFORE OPERATING YOUR UNIT. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. Install this sound system in a well ventilated, cool, dry, clean place - away from direct sunlight, heat sources, vibration, dust, moisture, and/or cold. For proper ventilation, allow the following minimum clearances around this unit.
CONTENTS Front panel ........................................................2 Rear panel .........................................................4 Remote control..................................................6 PLAYBACK................................................. 11 Playing a source ............................................. 11 Adjusting to the desired sound ....................... 12 TROUBLESHOOTING.............................. 13 SPECIFICATIONS .....................................
CONTROLS AND FUNCTIONS Front panel (A-S701) 1 A (power) switch Turns on and off the power of this unit. 4 PHONES jack Connect your headphones. Note 5 SPEAKERS selector Even when this unit is turned off, this unit consumes a small amount of power. 2 Power indicator Indicator Status Brightly lit The power of this unit is “on”. Dimly lit This unit is in “standby” mode. For details on the “standby” mode, see page 6. Off The power of this unit is “off”.
CONTROLS AND FUNCTIONS English (A-S701) 8 BALANCE control Adjusts the sound output balance of the left and right speakers to compensate for sound imbalances. Note If you rotate the BALANCE control to the end of L (left) or R (right), the opposite side of channel is muted. 9 LOUDNESS control Retain a full tonal range at any volume level (see page 12). 0 INPUT selector and indicators Selects the input source you want to listen to.
CONTROLS AND FUNCTIONS Rear panel (A-S501/S301) (A-S701) 1 CD input jacks Used to connect a CD player (see page 9). 2 PHONO jacks and GND terminal Used to connect a turntable that uses an MM cartridge, and to ground the terminal (see page 9). 3 Audio input/output jacks Used to connect external components, such as a tuner, etc (see page 9). 4 DIGITAL (OPTICAL) jack Used to connect a component with a digital optical output (see page 9).
CONTROLS AND FUNCTIONS (A-S501/S301) English (A-S701) 0 VOLTAGE SELECTOR (General model only) Used to set to your local main voltage (see page 10). A IMPEDANCE SELECTOR switch CAUTION Do not change the IMPEDANCE SELECTOR switch while the power is turned on, as doing so may damage the unit. If the IMPEDANCE SELECTOR switch may not be fully slid to either position, remove the power cable and slide the switch all the way to either position.
CONTROLS AND FUNCTIONS Remote control (A-S701) 1 Infrared signal transmitter Sends infrared signals. 2 A AMP Turns this unit on, or sets it to standby mode. 3 OPEN/CLOSE Opens/closes the disc tray of the Yamaha CD player. Refer to the owner’s manual of your CD player for details. Note Even when using a Yamaha CD player, certain components and features may not be available. (A-S501/S301) 4 A CD Turns the Yamaha CD player on, or sets it to standby mode.
CONTROLS AND FUNCTIONS 7 VOLUME +/– Increases or decreases the sound output level. 9 PURE DIRECT Reproduces any input source in the purest sound possible (see page 12). 0 Yamaha tuner control buttons The following buttons can be used to control various functions of a Yamaha tuner. Refer to your component’s owner’s manual for more information.
CONTROLS AND FUNCTIONS ■ Installing batteries AA, R6, UM-3 batteries ■ Operation range Point the remote control at the remote control sensor on this unit and remain within the operating range shown below. Approximately 6m (20 ft) Remote control ■ • • • • • • • • • • • • Notes on remote control and batteries The area between the remote control and this unit must be clear of large obstacles. Be careful not to spill water or other liquids on the remote control.
CONNECTIONS Make sure to connect L (left) to L, R (right) to R, “+” to “+” and “–” to “–”. If the connections are faulty, no sound will be heard from the speakers, and if the polarity of the speaker connections is incorrect, the sound will be unnatural and lack bass. Refer to the owner’s manual for each of your components. Make sure to use RCA cables or optical cable to connect audio components.
CONNECTIONS ■ REC jacks Rear panel • The audio signals are not output via the LINE 2 REC or LINE 3 REC output jacks when LINE 2 or LINE 3 is selected with the INPUT selector. • The VOLUME, BASS, TREBLE, BALANCE and LOUDNESS controls and the CD DIRECT function (or the PURE DIRECT function) have no effect on the source being recorded. Speaker ■ Connecting speaker cables 1 Remove approximately 10 mm (3/8 in) of insulation from the end of each speaker cable.
PLAYBACK SPEAKERS 4 VOLUME Rotate the SPEAKERS selector on the front panel to select SPEAKERS A, B or A+B BIWIRING. y Set the SPEAKERS selector to the A+B BI-WIRING position when two sets of speakers are connected using bi-wire connections, or when using two sets of speakers simultaneously (A and B). (A-S701) A 5 Play the selected input source. 6 Rotate the VOLUME control on the front panel (or press VOLUME +/– on the remote control) to adjust the sound output level.
PLAYBACK Adjusting to the desired sound LOUDNESS VOLUME ■ Reproducing pure, high fidelity sound (PURE DIRECT) When the PURE DIRECT function is on, noise can be reduced by bypassing the circuit that the audio input signal is not using and stopping the power supply to the circuit. Therefore, in all input sources, you can enjoy music playback in straight and high quality sound. The indicator above the PURE DIRECT button lights up when this function is turned on.
TROUBLESHOOTING Problem This unit fails to turn on. This unit turns off suddenly and the power indicator blinks. Cause See page The power cable is not connected or the plug is not completely inserted. Connect the power cable firmly. The A AMP is pressed on the remote control while this unit is turned off. Press A (power) switch on the front panel to on. The impedance setting of the connected speaker is too small. Use speaker(s) with proper speaker impedance.
TROUBLESHOOTING Problem Cause Remedy See page Playback has been stopped on the connected component. Turn the component on and start playback. No appropriate input source has been selected. Select an appropriate input source with the INPUT selector on the front panel (or one of the Input selector buttons on the remote control). 11 The SPEAKERS selector is not set properly. Set the corresponding SPEAKERS selector to A, B or A+B BI-WIRING position.
SPECIFICATIONS AUDIO SECTION Minimum RMS output power A-S701 A-S501 A-S301 8 Ω, 20 Hz to 20 kHz, 0.019% THD 100 W + 100 W 85 W + 85 W 60 W + 60 W 6 Ω, 20 Hz to 20 kHz, 0.038% THD (Except for Asia and China models) 120 W + 120 W 100 W + 100 W 70 W + 70 W 8Ω 140 W 130 W 100 W 6Ω 170 W 150 W 120 W 4Ω 220 W 185 W 140 W 2Ω 290 W 220 W 150 W Maximum power per channel 1 kHz, 0.7% THD, 4 Ω (U.K. and Europe models only) 160 W 120 W 95 W IEC power 1 kHz, 0.019% THD, 8 Ω (U.K.
SPECIFICATIONS Item Signal to noise ratio (IHF-A network) A-S701 A-S501 PHONO (MM) (5 mV input shorted) 82 dB or more CD, etc. PURE DIRECT on (200 mV input shorted) 99 dB or more CD DIRECT AMP on 104 dB or more Residual noise (IHF-A network) Channel separation A-S301 — — 40 μV CD, etc. (5.1 kΩ input shorted, 1 kHz) 65 dB or more CD, etc. (5.
Printed in Malaysia ZM52680
fi)YAMAHA For details of products, please contact your nearest Yamaha representative or the authorized distributor listed below. Pour plus de details sur les produits, contactez votre representant Yamaha le plus proche de chez vous ou le distributeur agree indique ci-dessous. I NORTH AMERICA CANADA Yamaha Canada Music Ltd. 135 Milner Avenue, Tronto ON M1S 3R1, Canada U.S.A. Yamaha Corporation of America 6600 Orangethorpe Ave., Buena Park, Calif. 90620, U.S.A.
I MIDDLE EAST TURKEY/CYPRUS Yamaha Music Europe GmbH Siemensstrasse 22-34, 25462 Rellingen, Germany I I ASIA --] SINGAPORE Yamaha Music (Asia) PRIVATE LIMITED Blk 202 Hougang Street 21, #02-00, Singapore 530202, Singapore THE PEOPLE'S REPUBLIC OF CHINA Yamaha Music & Electronics (China) Co.,Ltd. 2F, Yunhedasha, 1818 Xinzha-lu, Jingan-qu, Shanghai, China TAIWAN Yamaha Music and Electronics Taiwan Co., Ltd. 3F, #6, Sec.2, Nan Jing E. Rd., Taipei, Taiwan, R.O.
.YAMAHA Registering Your New Yamaha Product is Fast and Easy Thank you for purchasing a new product from Yamaha Electronics. We'd like to continue providing you with high quality products and better service. So, we've made it simple to register your new product purchase online. Please take a few minutes to visit our website at www.yamaha.com/YEC/registration/ and complete the information and questions included there. We appreciate your business and we look forward to hearing from you.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ ~~~~~~~~~~ b'.'::~"'·"'"'·'b'.'<>o-.,.,b-~bl:<'ii!J.~b'.'<~ ~ ~ ~ m ~ ~ ~ ~ ~ ~ ~ ~ ~~ ·~ GARANTXE DE§ A JPP>AREKL§ §TEREOJPHO NKQUE§ YA1\1AHA ~ Yamaha Canada Musique Ltee.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ ~~~::?6r>.::<>~i!'.-ai!'...~i!'.'•.,i!'•.,i!'.-aO'•.,i!'.?6i!>::::
.YAMAHA LIMITED WARRANTY ON HOME AUDIO PRODUCTS Thank you for selecting a YAMAHA product. YAMAHA products are designed and manufactured to provide a high level of defect-free performance. Yamaha Corporation of America ("YAMAHA") is proud of the experience and craftsmanship that goes into each and every YAMAHA product.
