Owner's Manual
COMMAND Pages
104
Chapter 4 PLAY Mode
SETINIT (Set Program’s Initial Conditions)
Sets default values for the selected program’s effect, setup, and control settings.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Press the COMMAND key, then turn Knob 1 to select >SETINIT.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔✔ -
Push action ✔ ----
Use this page to register the selected program’s current EFFECT, SETUP, and/or CON-
TROL settings as that program’s default (initial) settings. The settings that you register
here will automatically take effect whenever power is turned on, and whenever you
reinitialize the program with the INIT command. (☞101)
The “EFFECT, SETUP, and CONTROL settings” are the settings that you make using
PLAY mode’s EFFECT, SETUP, and CONTROL functions.
As an example, assume that you want to set the program so that it uses “reverb” as its
default Effect 1. To do this, you would (a) select the program, (b) go to PLAY | EFFECT
and set Effect1 to “reverb”, and then (c) come to the SETINIT command page, set [EF-
FECT] (Knob 2) to on, and then push Knob 1 to execute.
Important
• The settings that you make here are stored in nonvolatile memory, and are not lost at
power-off.
• The A3000 accepts initial settings only for the program’s EFFECT, SETUP, and CON-
TROL parameters. You cannot set your own default values for program’s PROGRAM,
SAMPLE, and EASY EDIT settings.
Knob 1 Change Page >SETINIT
• Turn the knob to change to a different command page.
• Push the knob to initialize the selected settings. The A3000 returns a confirmation
screen. Push Knob 5 (>YES) to proceed, or Knob 4 (>NO) to cancel.
Knob 2 [EFFECT] = off, on
Set this on if you want to register the program’s current EFFECT settings as the pro-
gram’s default effect values.
Knob 3 [SETUP] = off, on
Set this on if you want to register the program’s current SETUP settings as the pro-
gram’s default setup values.
Knob 4 [CONTROL] = off, on
Set this on if you want to register the program’s current CONTROL settings as the
program’s default control values.