Owner's Manual
115
Chapter 4 PLAY Mode
Chapter 4
SAMPLE Function
SAMPLE - ToBank (Assign Sample to Bank)
Places a sample into a sample bank.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select ToBank.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔✔ -
Push actio ✔ - ✔✔✔
Use this page to set samples into sample banks.
FYI
• You cannot use this page to create a new sample bank. To create a sample bank, use
the NEWBANK command page instead (press the COMMAND key and go to the
>NEWBANK command page). (☞105).
• To remove a sample from a sample bank, use the REMOVE page. (☞114)
Knob 1 Change Page Select P/S
• Turn the knob to change to a different page within the SAMPLE function. Available
pages are: SmpSel, SmpBank, ToBank (this page), and SmpSort.
• Push the knob to move to the Program/Sample Selection screen. (☞95)
Knob 2 Sample bank = bank name
• Turn this knob to select the destination sample bank.
• If you select a new or edited sample bank that has not yet been saved to disk in its
current form, an [E] (“edited”) mark appears in front of the name.
Knobs 3, 4
Sample = sample name Edit the Name
• Turn either knob to select the sample that you want to add to the sample bank.
• If you wish to set or change the name of the selected sample, push either knob to
proceed to the name-editing screen. For information about how to edit name strings,
see “Entering Names” (☞88).