Owner's Manual

125
Chapter 4 PLAY Mode
Chapter 4
EFFECT Function
■ If “EffectEditType” is set to “favorite”, the page looks like this.
Sets parameters for the selected effect (Effect 1, 2, or 3).
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select Efct1, Efct2, or Efct3.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔✔✔
Push action ✔✔✔✔✔
Use this page to set parameter values for the selected effect (Effect 1, 2, or 3). The screen
displays the four “favorite” parameters for this effect. You can set the values with Knobs
2 to 5, or change the “favorite” selection by pressing any of the Knobs 2 to 5.
Knob 1 Change Page Select P/S
• Turn the knob to change to a different page within the EFFECT function. Available
pages are: EfType, Efct1, Efct2, Efct3, In&Out, and EdType.
• Push the knob to move to the Program/Sample Selection screen. (☞95)
Knobs 2 to 5 Value = parameter name Select Parameter
Each knob sets the value for one parameter. The parameter name appears on the top
line of the screen, and the current value on the second line. Turn the knob to change the
value.
Although each effect offers a large number of parameters, this screen only shows four
“favorites.” As the factory default, the screen shows the four most important (most in-
fluential) parameters.
You can change the “favorite” grouping by pressing any knob between 2 and 5, produc-
ing a screen such as shown above. You can then turn Knobs 2 through 5 to select new
favorites. When you are ready to return to the value-setting screen, press one of the
knobs (Knobs 2 to 5) again.