Owner's Manual

126
Chapter 4 PLAY Mode
EFFECT Function
EFFECT - In&Out (Input/output levels and pan)
Sets input level, output level, and pan for each effect (Effects 1, 2, and 3).
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select In&Out.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔✔✔
Push action ✔ ----
Use this page to set the input level, output level, and pan for each of the three effect
blocks (Effect 1, Effect 2, and Effect 3).
Knob 1 Change Page Select P/S
• Turn the knob to change to a different page within the EFFECT function. Available
pages are: EfType, Efct1, Efct2, Efct3, In&Out (this page) and EdType.
• Push the knob to move to the Program/Sample Selection screen. (☞95)
Knob 2 Effect# = 1, 2, 3
Turn the knob to select the effect block (Effect 1, 2, or 3) whose values you want to set.
You can then set the various values using Knobs 3, 4, and 5. You can repeat the sequence
to set each of the three effects: first select the effect block with Knob 2, then set the
values with Knobs 3, 4, and 5.
Knob 3 InLevel = 0,...,127
Turn the knob to set the input level for the selected effect block.
Knob 4 OutLevel = 0,...,127
Turn the knob to set the output level for the selected effect block.
Knob 5 Pan = -63,...,+63
Turn the knob to set the pan (stereo positioning) for the effect block’s output. Positive
values set pan to the right; negative values set pan to the left.
If the effect output is stereo, higher absolute pan settings will narrow the stereo feeling
while noticeably shifting the sound position.