Owner's Manual

134
Chapter 4 PLAY Mode
SETUP Function
SETUP - ADOut (Output Setup for A/D-Input Signal)
Selects the output destinations for the A/D-in signal, and sets the output levels.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select ADOut.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔✔✔
Push action ✔ ----
This page sets the main and assignable output destinations and levels for the A/D-in
signal.
Knob 1 Change Page Select P/S
• Turn the knob to change to a different page within the SETUP function. Available
pages are: PgmMstr, Portmnt, ADSetup, and ADOut (this page).
• Push the knob to move to the Program/Sample Selection screen. (☞95)
Knob 2 MainOut = off, Stereo, Effect1, Effect2, Effect3
Selects the main output destination for the A/D-input signal. Available settings are as
follows.
off The signal does not flow to any main output. Use this setting
when you want to output the signal through assignable outputs
only (see below).
Stereo Output the signal directly to the stereo outputs, bypassing all
effects.
Effect1,...,Effect3 Pass the signal through the selected effect block (Effect 1, Effect
2, or Effect 3), and output the result to the stereo outputs.
Knob 3 Level = 0,...,127
Sets the output level at the main output.