Owner's Manual

141
Chapter 4 PLAY Mode
Chapter 4
CONTROL Function
CONTROL - Reset (Controller Reset)
Selects whether controllers initialize when you switch into this program.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select Reset.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔ --
Push action ✔ ----
This page selects how controllers are set when you switch into this program from an-
other program. You can choose to retain the previous control-change values, or else to
temporarily reset these values to 0. You can set the operation separately for each MIDI
channel.
For more information, refer to the supplementary explanation on the next page.
Knob 1 Change Page Select P/S
• Turn the knob to change to a different page within the CONTROL function. Available
pages are: PgmCtl1, PgmCtl2 and Reset (this page).
• Push the knob to move to the Program/Sample Selection screen. (☞95)
Knob 2 MIDICh = 1,...,16
Selects the MIDI Receive Channel. After selecting the channel, you can use Knob 3 to
select whether controllers are reset for the samples that play on that channel (see next
page).You can then repeat this sequence as necessary: Use Knob 2 to select another
channel, then use Knob 3 to enable or disable controller reset for that channel.
Knob 3 CtlReset = off, on
Selects whether the controller control-change values currently set for the previous pro-
gram reinitialize to 0 when you switch into this program. You can set the operation
separately for each MIDI Receive Channel.
off Maintain previous values.
on Return values to 0.