Owner's Manual

COMMAND Pages
160
Chapter 5 EDIT Mode
SETINIT (Register Initial Parameter Values)
Registers current parameter values as “initial” values.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Press the COMMAND key, then turn Knob 1 to select >SETINIT.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔ ----
Push action ✔ ----
This command registers the selected sample’s parameter settings (filter settings, LFO
settings, EG settings, and so on) as the default values to be used for new samples. If the
current sample is set to use a HiPass1 filter, for example, then any subsequent sample
that you record will also be initially set to use a HiPass1 filter.
Important
This command does not operate on sample banks.
FYI
The initial settings are stored in nonvolatile memory, and are not lost at power-off.
Knob 1 Change Page >SETINIT
• Turn the knob to change to a different command page.
• Push the knob to register the new initial values. The A3000 returns a confirmation
screen. Push Knob 5 (>YES) to proceed, or Knob 4 (>NO) to cancel.