Owner's Manual
166
Chapter 5 EDIT Mode
TRIM/LOOP Function
TRIM/LOOP - Loop (Edit Loop Addresses)
Sets loop start and loop end addresses.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select Loop.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔✔✔
Push action ✔✔✔✔✔
Use this page to select the start and end points for the playback loop.
FYI
• To set the loop mode (loop direction and type), use the WvMode page. (☞168)
• You can use the EndType setting on the Configure page to select the method for
displaying the end address. (☞161)
Knob 1 Change Page Select P/S
• Turn the knob to change to a different page within the TRIM/LOOP function. Avail-
able pages are: Config, Wave, Loop (this page), and WvMode.
• Push the knob to move to the Program/Sample Selection screen. (☞95)
Knob 2 LpStart
=
loop start address
,...,
end address
Realtime Set
• Sets the start point of the loop on the waveform. The concept is illustrated below.
• Note that actual loop handling depends on the loop-mode setting. (☞168)
Start Address
Playback Area of Waveform
Loop Start Address Loop End Address
End Address
Looping Area