Owner's Manual

172
Chapter 5 EDIT Mode
MAP/OUT Function
MAP/OUT - VelRnge (Velocity Range)
Sets the velocity range, velocity sensitivity, and velocity crossfade.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select VelRnge.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔✔✔
Push action ✔✔✔ --
Use this page to set the sample’s velocity range, velocity sensitivity, and velocity crossfade.
Knob 1 Change Page Select P/S
• Turn the knob to change to a different page within the MAP/OUT function. Available
pages are: KeyRnge, VelRnge (this page), Lvl&Mode, Output, Pitch, Expand, and LvlScale.
• Push the knob to move to the Program/Sample Selection screen. (☞95)
Knob 2 Low = 0,..., High velocity MIDI IN
• Turn the knob to set the minimum velocity required to produce sound from this
sample. (But refer also to the explanation for Knob 4, below.)
• Push the knob if you want to set the value using an external MIDI device. The knob
indicator begins blinking, indicating that the A3000 is ready to receive MIDI input.
Now transmit any note, taking care to use the appropriate velocity (key-strike force).
Once you have made the correct setting, lock it in by pressing the knob again (or else
press a different MIDI IN knob, or change to a different screen).
Knob 3 High = Low velocity ,...,127 MIDI IN
• Turn the knob to set the maximum velocity that can be used to produce sound from
this sample. (But refer also to the explanation for Knob 4, below.)
• Push the knob if you want to set the value using an external MIDI device. (See expla-
nation above.)