Owner's Manual

178
Chapter 5 EDIT Mode
MAP/OUT Function
MAP/OUT - Pitch
Sets the sample’s pitch characteristics.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select Pitch.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔✔✔
Push action ✔ ----
Use this page to set the sample’s tuning and pitch characteristics.
Knob 1 Change Page Select P/S
• Turn the knob to change to a different page within the MAP/OUT function. Available
pages are: KeyRnge, VelRnge, Lvl&Mode, Output, Pitch (this page), Expand, and LvlScale.
• Push the knob to move to the Program/Sample Selection screen. (☞95)
Knob 2 Coarse = -127,...,+127
Turn the knob to adjust the sample’s pitch, in semitone increments.
Knob 3 Fine = -63,...,+63
Turn the knob to fine-tune the sample’s pitch. Each click adjusts the pitch by 1.171875
cent. (Note: 100 cents = 1 semitone)
Knob 4 Fixed = off, on
Set this parameter on if you want the sample to play out at the same pitch over its entire
key range.
Knob 5 Random = 0,...,63
Use this setting to impart a slight, random pitch variation to the sample’s pitch.
Set to 0 to eliminate all random variation. Increase the value to produce a greater range
of variation.
Note that this variation is applied to each note at the start of its playback. This setting
does not affect how pitch develops once the note has started playing.