Owner's Manual

196
Chapter 5 EDIT Mode
EG Function
EG - FEGMode (FEG Mode Settings)
Sets up the FEG’s scaling and velocity sensitivities.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select FEGMode.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔✔✔
Push action ✔ ----
Use this page to determine how FEG rates vary with keyboard location and velocity, and
how FEG levels vary with velocity.
Knob 1 Change Page Select P/S
• Turn the knob to change to a different page within the EG function. Available pages
are: AEG, AEGMode, FEGRate, FEGLevel, FEGMode (this page), PEGRate, PEGLevel,
and PEGMode.
• Push the knob to move to the Program/Sample Selection screen. (☞95)
Knob 2 RateScl = -7,...,+7
This setting determines how the FEG rates (attack, decay, and release rates) vary ac-
cording to keyboard location (pitch) of the played note.
Set the value to 0 to keep rates the same for all keyboard notes. Positive settings cause
rates to increase as you move up the keyboard, while negative settings cause rates to
decrease as you move up the keyboard.
Knob 3 Vel → Rate = -63,...,+63
This value sets the velocity sensitivity of the FEG rates: the amount by which the FEG
rates (attack, decay, and release rates) vary in response to the velocity (force) of the
played note.
Set the value to 0 to keep rates the same for all velocities. Positive settings cause rates to
increase as velocity increases, while negative settings cause rates to decrease as velocity
increases.