Owner's Manual

201
Chapter 5 EDIT Mode
Chapter 5
EG Function
EG - PEGMode (PEG Mode Settings)
Sets up the PEG’s scaling, velocity sensitivity, and range.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select PEGMode.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔✔ -
Push action ✔ ----
Use this page to determine how PEG rates vary with velocity and keyboard location, and
how the PEG levels vary with velocity. Also use it to set the range for the PEG levels.
Knob 1 Change Page Select P/S
• Turn the knob to change to a different page within the EG function. Available pages
are: AEG, AEGMode, FEGRate, FEGLevel, FEGMode, PEGRate, PEGLevel, and
PEGMode (this page).
• Push the knob to move to the Program/Sample Selection screen. (☞95)
Knob 2 RateScl = -7,...,+7
This setting determines how the PEG rates (attack, decay, and release rates) vary ac-
cording to keyboard location (pitch) of the played note. Set the value to 0 to keep rates
the same for all keyboard notes. Positive settings cause rates to increase as you move up
the keyboard, while negative settings cause rates to decrease as you move up the key-
board.
Knob 3 Vel → Rate = -63,...,+63
This value sets the velocity sensitivity for the PEG rates: the amount by these PEG rates
(attack, decay, and release rates) vary in response to the velocity (force) of the played
note.
Set the value to 0 to keep rates the same for all velocities. Positive settings cause rates to
increase as velocity increases, while negative settings cause rates to decrease as velocity
increases.