Owner's Manual

205
Chapter 5 EDIT Mode
Chapter 5
LFO Function
LFO - FltrMod (Filter Modulation)
Sets LFO filter modulation.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select FltrMod.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔ --
Push action ✔ ----
This page determines how the LFO waveform acts upon (modulates) the filter cutoff
frequency.
Important
These settings are meaningless if the Type parameter on the Filter page (☞182) is set to
Bypass.
Knob 1 Change Page Select P/S
• Turn the knob to change to a different page within the LFO function. Available pages
are: Common, FltrMod (this page), PtchMod, and AmpMod.
• Push the knob to move to the Program/Sample Selection screen. (☞95)
Knob 2 Depth = 0,...,127
This value sets the degree by which the filter’s cutoff frequency is modulated by the LFO
waveform. Higher values produce stronger modulation.
Knob 3 PhaseInvert = off, on
Set this value to on if you want to invert the waveform used to modulate the filter.
If the setting is on, the A3000 modulates the cutoff frequency using the inverse of the
selected LFO waveform. (The inverse is obtained by rotating the actual LFO waveform
180 degrees with respect to the time axis. The actual LFO waveforms are shown on page
204.)