Owner's Manual

208
Chapter 5 EDIT Mode
MIDI/CTRL Function
MIDI/CTRL Function
You use the MIDI/CTRL function to set the sample’s MIDI Receive Channel, to designate
its “alternate group,” and to set up its controller handling.
FYI
The COMMAND key gives you rapid access to a number of helpful commands while you
are working with this function. For example, you can use the COMMAND key when you
want to save your edit results to disk, or when you want to cancel your new changes and
restore the previously saved data. (☞147)
MIDI/CTRL - RCh&Alt (Receive Channel and Alternate
Sets the sample’s MIDI Receive Channel and “alternate group.”
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select RCh&Alt.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔ - ✔ -
Push action ✔✔ ---
You use this page to set the sample’s MIDI Receive Channel, and to assign the sample to
an “alternate group.”
Important
If you set the sample into an alternate group (if you set the AlternateGroup parameter to
any value other than “off”), you will not be able to play more than one note at a time
from the sample, since each new note from the sample automatically switches off any
preceding note from the sample.
Knob 1 Change Page Select P/S
• Turn the knob to change to a different page within the MIDI/CTRL function. Avail-
able pages are: RCh&Alt (this page), SmpCtl1, SmpCtl2, and Vel&PB.
• Push the knob to move to the Program/Sample Selection screen. (☞95)