Owner's Manual

210
Chapter 5 EDIT Mode
MIDI/CTRL Function
MIDI/CTRL - SmpCtl1 (Sample Controller Setup 1)
Sets up the sample’s controller usage.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select SmpCtl1.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔✔✔
Push action ✔ - ✔ --
You use this page together with page SmpCtl2 to set up the controller matrix that
determines how selected MIDI controllers operate on the sample’s playback. The matrix
selects up to six controllers, and assigns to each of these a specific function and operat-
ing range. A conceptual illustration of the matrix is shown below.
Matrix#
1
2
3
4
5
6
Device Function Type Range
Matrix No
Selects the controlled parameter.
Sets the maximum control range.
Selects a controller.
Determines how the A3000 converts
the received controller values.
You use the SmpCtl1 page to set the Device and Function values only. Use page SmpCtl2
(☞213) to set the Type and Range values.
Knob 1 Change Page Select P/S
• Turn the knob to change to a different page within the MIDI/CTRL function. Avail-
able pages are: RCh&Alt, SmpCtl1 (this page), SmpCtl2, and Vel&PB.
• Push the knob to move to the Program/Sample Selection screen. (☞95)