Owner's Manual

227
Chapter 6 RECORDING Mode
Chapter 6
SETUP Function
SETUP Function
You use the SETUP function to set up for a recording — to select the input source, to set
the recording start and stop methods, and to set a wide variety of other setup param-
eters.
SETUP - RecData
Sets basic recording parameters.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select RecData.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔✔✔
Push action ✔ ----
You use this page to designate the input source, to select the sample type (monaural or
stereo), and to set the sampling frequency and the pretrigger time.
Knob 1 Change Page Select P/S
• Turn the knob to change to a different page within the SETUP function. Available
pages are: RecData (this page), Target, KeyRnge, Trigger, and Process.
• Push the knob to move to the Program/Sample Selection screen. (☞95)
Knob 2 Input = AD L, AD L/R, STOut, DIGITAL, OPTICAL
This setting selects the input source for the recording. Note that the DIGITAL and
OPTICAL settings are effective only if you have installed the optional I/O expansion
board (AIEB1 board).
AD L Record analog signal from the front panel’s INPUT-L jack.
AD L/R Record analog signal from both front-panel input jacks (INPUT-
L and INPUT-R).
STOut Record the signal that the A3000 is producing and transmitting
to its own stereo outputs. (A process called resampling: the A3000
re-records its own signal. You use this setting to record playback
that you control from a MIDI keyboard or other such device.)