Owner's Manual

232
Chapter 6 RECORDING Mode
SETUP Function
SETUP - KeyRnge
Sets the key range and “original key” for the new sample(s).
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select KeyRnge.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔✔ -
Push action ✔✔✔✔ -
You use this page to set the key range and “original key” settings for the sample(s) that
you are about to record.
Note that you cannot set these values if the Target page (☞230) is set up in either of the
following ways.
• If the Sample parameter is set to Replace. In this case, the existing sample’s settings
are automatically retained.
• If the Sample parameter is set to New+ and the ToPgm parameter is set to
C1→,...,C5→.
FYI
You can use the Note setting in the UTILITY | SYSTEM Display page (☞302) to select
whether key values are shown by name (“C-2” to “G8”) or by the corresponding MIDI
note number (0 to 127). Descriptions below assume that you are using name display.
Knob 1 Change Page Select P/S
• Turn the knob to change to a different page within the SETUP function. Available
pages are: RecData, Target, KeyRnge (this page), Trigger, and Process.
• Push the knob to move to the Program/Sample Selection screen. (☞95)
Knob 2 OrigKey = C-2,...,G8 MIDI IN
• Turn the knob to set the sample’s “original key” — the key that best represents the
sample’s inherent pitch.
• Push the knob if you want to set the value using MIDI input. Be sure that the knob
indicator is blinking, then transmit the note from your MIDI device. Then lock the
value in by pushing the same knob again or by changing to a different screen.