Owner's Manual

245
Chapter 6 RECORDING Mode
Chapter 6
MONITOR Function
MONITOR - Click
Creates a “click” sample.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select Click.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔✔✔
Push action ✔ ----
• Use this page to set up a metronome sound that you can use to help time the record-
ing of drum and percussion phrases.
• When you set Click to on (Knob 5), the A3000 generates a special sample (named
“Click”) in main memory. (The A3000 will not create the sample, however, if a sample
with this name already exists.) It then uses the sample to produce the metronome
sound while you are working in RECORDING mode.
• You can select the output destination for the click by editing the “Click” sample.
Knob 1 Change Page Select P/S
• Turn the knob to switch between the function’s Monitor and Click pages.
• Push the knob to move to the Program/Sample Selection screen. (☞95)
Knob 2 Tempo = 80:00,...,159.99
Sets the tempo for the click.
Knob 3 Level = 0,...,127
Sets the output level for the click.
Knob 4 Beat = 1,...,15
Sets the number of beats.
Knob 5 Click = off, on
• Set this on if you want to output the click sound. If the setting is on, the A3000
continues to generate the click while you are working in RECORDING mode.
• If the setting is on, the A3000 will include click information into the samples that
you record. The information is set into the sample’s parameter data, and does not
affect the waveform itself. You can later use the click data as an aid when editing the
sample’s waveform addresses. (☞164, 166)