Owner's Manual

271
Chapter 7 DISK Mode
Chapter 7
DISK Function
DISK - SelfID
Sets the SCSI ID of the A3000.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select SelfID.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔ ---
Push action ✔ ----
Use this page to set the SCSI ID of the A3000.
Important
• There is generally no need to change the ID from its factory setting (ID 7). You will
need to make this change only if you are connecting up another SCSI device that has
a fixed (unchangeable) ID of 7.
• Be sure that the ID that you set here does not match the ID of any other device in
your system — since all devices must have different IDs. To check for currently used
IDs, use the Config page (☞270).
• The ID that you set here does not become effective until you switch the power off and
then back on.
Knob 1 Change Page Select P/S
• Turn the knob to change to a different page within the DISK function. Available
pages are: Disk, Config, and SelfID (this page).
• Push the knob to move to the Program/Sample Selection screen. (☞95)
Knob 2 A3000 ID = 0,...,7
Turn the knob to set the new ID. (The new setting does not become effective until you
switch power off and then back on.)