Owner's Manual

309
Chapter 8 UTILITY Mode
Chapter 8
MIDI Function
MIDI - RcvFlt (Receiving Filter)
Sets up filtering of MIDI data.
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
PLAY
EDIT
REC
DISK
UTILITY
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Turn Knob 1 to select RcvFlt.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn action ✔✔✔✔ -
Push action ✔ ----
This page selects the types of MIDI messages accepted by the A3000. The A3000 accepts
messages of a given type only if the corresponding parameter is set to enable. If the
setting is disable, the A3000 filters out (ignores) messages of this type.
Note that the settings that you make here remain effective when you are recording a
sequence. If you disable control-change messages, for example, then the sequence will
not register any control-change messages that are received during recording.
Knob 1 Change Page Select P/S
• Turn the knob to change to a different page within the MIDI function. Available pages
are: Receive, Adjust, RcvFlt (this page), and Bulk.
• Push the knob to move to the Program/Sample Selection screen. (☞95)
Knob 2 CtrlCng = enable, disable
Set this to enable if you want to allow control-change data to pass to the tone generator.
Set to disable if you want the A3000 to ignore (filter out) all control-change data.
Knob 3 AftrTch = enable, disable
Set this to enable if you want to allow aftertouch data to pass to the tone generator. Set
to disable if you want the A3000 to ignore (filter out) all aftertouch data.
Knob 4 PtchBnd = enable, disable
Set this to enable if you want to allow pitchbend data to pass to the tone generator. Set
to disable if you want the A3000 to ignore (filter out) all pitchbend data.