Owner's Manual

Troubleshooting
348
Appendix
Troubleshooting
If you experience problems such as “no sound” or “incorrect pitch,” refer to this section and
make sure that the A3000 and your other equipment has the correct settings.
No sound
• Is the power of the A3000 and your external equipment turned on?
• Are MIDI cables and audio cables connected correctly between the A3000 and the
external equipment? (☞22—29)
• Is the MASTER VOL knob raised? (☞8)
When there is a problem with the program settings
• Is the program setting ToPgm turned ON for the desired sample in memory? (☞112)
• In the EASY EDIT settings, have you modified the sample keyboard range or velocity
range, or the MIDI receive channel? (☞118)
• Are the effect settings InLevel or OutLevel set to 0? (☞126)
• Is Level set to 0? (☞128)
• If an external controller has been set to control program level, is that controller in
the 0 position? (☞136)
When there is a problem with the sample settings
• Are the key range settings Low and High set correctly? (☞170)
• Are the velocity range settings Low and High set correctly? (☞172)
• Is Level set to 0? (☞174)
• Is a setting other than OFF selected for MainOut or AsgnOut? (☞176)
• For some samples, strongly applying a filter may mean that the sound cannot be
heard at all. (☞182)
• Is the AEG AtkRate set to an extremely low value? (☞188)
• Is the MIDI receive channel of the sample set correctly? (☞208)
• If an external controller has been set to control sample level, is that controller in the
0 position? (☞210)