Owner's Manual

Troubleshooting
350
Appendix
Other problems
Cannot use the A/D input function
• Is the program’s A/D In setting turned ON? (☞132)
• Is the A/D input MainOut or AsgnOut set to other than OFF? (☞134)
• Is the A/D input Level or AsLevel set to 0? (☞132)
Cannot make fine adjustments to the sample addresses
• Are Zero (auto zero) or Snap (auto snap) turned ON? (☞161)
Cannot play chords
• Is the sample parameter or easy edit parameter Poly/Mono set to Mono? (☞119, 174)
• Does the sample parameter or easy edit parameter Alternate Group have a setting
other than OFF? (☞119, 208)
Volume or tone differs depending on the pitch
• Is level scaling specified for the sample? (☞180)
• Is filter scaling specified for the sample? (☞185)
Tone, pitch or volume changes cyclically
• Is the sample’s LFO parameter FltrMod set to a Depth or 1 or more? (☞205)
• Is the sample’s LFO parameter PtchMod set to a Depth or 1 or more? (☞206)
• Is the sample’s LFO parameter AmpMod set to a Depth or 1 or more? (☞207)
• If an external controller has been set to control the Ptch Mod Depth, Amp Mod Depth
or Cutoff Mod Depth of a sample, is that controller raised (or lowered) ? (☞210)
Of the incoming MIDI messages, only specific MIDI messages are not received
• In the utility setting MIDI Receive Filter, are any of the settings CtrlChg, AftrTch or
PtchBnd set to “disable”? (☞309)