Owner's Manual

Sample Editing
56
Chapter 2 Trying It Out
Using the LFO
We will now set the LFO (low-frequency oscillator) to create a vibrato in the ahhhh
sample.
Procedure
1.
Select EDIT mode, LFO function.
2.
Press Knob 1, and then turn Knob 2 or Knob 3 to select the Voice AH sample
for editing. Then press Knob 1 again.
3.
Turn Knob 1 to select the PtchMod (pitch modulation) screen. Then turn
Knob 2 to set the Depth to 30.
▼The screen now looks like this.
4.
Turn Knob 1 to select the Common screen. Turn Knob 2 to set Wave to
Triangl. Turn Knob 3 to set Speed to 15; turn Knob 4 to set Delay to 90.
5.
Now play and hold a key between C2 and B2 at your keyboard.
Notice how a gentle vibrato (pitch waver) begins after the sound has been held for a few
moments.
In the next section we will begin to do some program editing.
If you wish to stop here for a while and switch off the power, please save your edited data
to floppy disk (☞64 to 66). When you are ready to resume operation, please reload the
data from the disk (☞67) and then proceed to the next page.
PLAY
EDIT
REC
DISK
UTILITY
PROGRAM
TRIM / LOOP
RECORD
PROGRAM
TOTAL EQ
SAMPLE
MAP / OUT
SETUP
SAMPLE
PANEL PLAY
EASY EDIT
FILTER
METER
SEQUENCE
SEQUENCE
EFFECT
EG
EFFECT
VOLUME
MASTER
SETUP
LFO
EXT CTRL
DISK
SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI