Owner`s manual

Changes in PLAY MODE

Chapter 2 Upgrade Reference

PLAY - EASY EDIT ☞ 119

Version 2 groups the Easy Edit parameters onto a number of pages so that they are

easier to work with, and adds a few new parameters.

The Easy Edit pages and parameters are as follows.

Page Parameters

Mix Level, Pan, MIDI Receive Channel

Output Main Output, Main Out level, Assignable Output, Assignable Out

Level

Filter Cutoff, Distance, Q/Width, Gain

Pitch Coarse, Fine

AEGRate AEG Attack Rate, Decay Rate, Release Rate

KeyLimit Key Range Shift, Key Low Limit, Key High Limit, Key Crossfade

VelLimit Velocity Low Limit, Velocity High Limit, Velocity Crossfade

Mode&Ctl Poly/Mono, Portamento, Alternate Group, MIDI Control

PLAY - EFFECT - EfType ☞ 121

Knob 5 offers two new Connect settings: 1/2 → 3 and 1 → 2 ← 3.

1/2 → 3 Output from Effect Block 2 passes through Effect Block 3. Effect

block 1 operates independently.

1 → 2 ← 3 Output from Effect Block 1 and output from Effect Block 3 both

pass through Effect Block 2.

PLAY - EFFECT - In&Out1, In&Out2 ☞ 126

Version 1’s In&Out page has been renamed In&Out1, and a new In&Out2 page has been

added.

You can use the new page to set the width and output destination for each of the effect

blocks.

• Knob 3 sets the effect block’s width (stereo expanse).

• Knob 4 sets the block’s output destination. On Version 1, output was always to the

A3000 stereo outputs. On Version 2, you can direct the output to the stereo outputs,

to any assignable-output pair, or to the digital output. Note that this setting is not

available for any effect block whose output is directed to another effect block (as set

up by the Connect parameter in the PLAY | EFFECT EfType page).