Owner`s manual

Changes in EDIT MODE

Chapter 2 Upgrade Reference

EDIT - FILTER - Filter ☞ 182

Version 2 includes the following additional filter types (Knob-2 Type settings).

LowPass3 Low pass filter #3

Peak1 Emphasis at a specified frequency

Peak2 Emphasis at specified frequency

2Peaks Emphasis at two specified frequencies

2Dips De-emphasis at two specified frequencies

DualLPFs Two low-pass filters

LPF+Peak Low-pass filter combined with peak filter

DualHPFs Two high-pass filters

HPF+Peak High-pass filter combined with peak filter

LPF+HPF Low-pass filter combined with high-pass filter

Note that if you select any of the final seven filters in the above listing, you will need to

set two frequencies. Use Knob 3 (Cutoff) to set the first of the frequencies; and then use

the new Distance parameter (at Knob 4) to set the second frequency by its (positive or

negative) distance from the first. Note that a 0 distance setting will cause the frequen-

cies to coincide. (For the LPF+Peak, HPF+Peak, and LPF+HPF frequencies, the Cutoff

value sets the frequency for the filter written at the left side, and the Distance setting

determines the frequency for the filter written at the right side.)

On Version 1, Knob 4 controlled the FltGain parameter. On Version 2, this parameter is

now located at Knob 5 in the FltSens page.

EDIT - FILTER - FltSens [Filter Sensitivity] ☞ 184

• Five new “random” settings, Rnd1 to Rnd5, have been added to the Vel → Cutoff and

Vel → Q/Width parameters at Knobs 2 and 4. You can select these settings by turn-

ing the knob to the right (so that it moves past +63). Each of values causes the

corresponding characteristic (frequency or Q/Width) to vary at random around its

true setting each time a note is played, where Rnd1 produces the smallest amount of

variation and Rnd5 produces the greatest.

• It is no longer possible to use Knob 3 to set the Vel → Cutoff parameter, or to use

Knob 5 to set the Vel → Q/Width parameter.

• Knob 5 now sets the FltGain (filter gain) parameter. On Version 1 this parameter was

located in the Filter page (see page 182 of the Owner’s Manual).