Owner`s manual

Changes in UTILITY MODE

Chapter 2

Chapter 2 Upgrade Reference

UTILITY - SYSTEM - Audition

This is a new page. This page is located between the Keys and Display pages in the

UTILITY | SYSTEM function. You can jump to this page from almost location by press-

ing COMMAND + AUDITION.

• Knob 2 (Effect) selects whether audition sound is passed through the program’s ef-

fects. Select on to pass the sound through the effects, or off to disconnect the effects.

Note that if you set the value to on and also set the MainOut parameter (EDIT | MAP/

OUT | Output page) to one of the effect blocks, you can use the audition feature to

hear how the selected effect sounds.

• Knob 3 (EasyEd) selects whether the program’s Easy Edit settings are applied to the

audition sound. Select on to apply the Easy Edit settings, or off to switch them off.

• Knob 4 (NameView) selects whether the screen displays the name of the sample

being played by the AUDITION key. Set to enable to display the name, or to disable to

suppress the display. If you set to enable, the name will appear on screen for about 1

second each time you play the audition.

• Knob 5 (TrigMode) sets the AUDITION key’s trigger mode. This parameter is equiva-

lent to Version 1’s AUDITION parameter (in Version 1’s Keys page). If you set the

mode to normal, the AUDITION key produces sound only while held down. If you set

the mode to toggle, each press of the key toggles audition playback on or off.

UTILITY - SYSTEM - Page ☞ 303

The atModeChange parameter at Knobs 2 and 3 now supports a new HoldFunction

setting. If you select this setting, the mode keys and function keys will operate inde-

pendently – the function-key selection will no longer change automatically each time

you press a different mode key. As a result, you will be able to move to any point in the

matrix by pressing the corresponding mode and function keys in either order.

UTILITY - SYSTEM - FreeMem [Free Memory] ☞ 304

This screen now both the free memory amount and the total memory amount. The

Wave(kB) value shows free_wave_memory/total_wave_memory, and the Param(kB) value

shows free_parameter_ memory/total_ parameter_ memory.