Operation Manual

EDIT-FILTER
136 Chapter 5 EDIT Mode • A5000/A4000 ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
Knob 3
[ Turn] Filter Scaling Breakpoint1
Specifies the lowest note from which the filter cutoff varia-
tion will begin. All notes lower than this will play at the cut-
off frequency specified by the Filter Scaling Cutoff1
parameter.
[Range] C-2 — G8 (Cannot be set higher than Filter Scal-
ing Breakpoint2)
• If the Note Display Type utility (UTILITY–SYSTEM-
Custom) (page 198) is set to "name" the parameter
will be displayed as note names such as "C3." If set
to "number" the parameter will be displayed as MIDI
note numbers such as "60."
[ Press] MIDI
When this knob is pressed the parameter can be directly
set by a MIDI note-on message received from an external
MIDI device.
Knob 4
[ Turn] Filter Scaling Breakpoint2
Specifies the high note at which the filter cutoff variation
will end. All notes higher than this will play at the cutoff
frequency specified by the Filter Scaling Cutoff2 parame-
ter.
[Range] C-2 — G8 (Cannot be set lower than Filter Scal-
ing Breakpoint1)
[ Press] MIDI
When this knob is pressed the parameter can be directly
set by a MIDI note-on message received from an external
MIDI device.
Knob 5
[ Turn] Filter Scaling Cutoff2
Sets the amount of filter cutoff variation at the Filter Scal-
ing Breakpoint2 note.
[Range] -127 — +127
[ Press] QUICK...
Calls the quick entry menu (page 83).