Operation Manual
About the COMMANDS
214 Chapter 9 COMMAND • A5000/A4000 ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
Knob 1
Same function as Cursor q (page 213).
Knob 3
[ Turn] From SampleBank
Selects the source Sample Bank for the freeze operation.
All Sample Banks in memory can be selected.
Knob 4
[ Turn] Loop Mode
Sets the Loop Mode. When the Freeze command is exe-
cuted the Loop Mode settings of all samples within the
target Sample Bank are set accordingly. All Loop Modes
can be selected (page 123).
• This parameter can only be used when the Freeze
Type is set to SampleBank&LpMode
→
Samples or
LpMode
→
Samples.
Knob 5
Same function as Cursor q (page 213).
REGISTER
[COMMAND/EXIT] Button →
Knob 1 to highlioght display line 2 → Press Knob 3.
This command registers the initial EFFECT, SETUP, and
CONTROL function settings which will be recalled whenever
the power is turned on or when a program is initialized (page
217) from the specified source program. It also registers the
initial sample parameters which will be recalled whenever a
sample is recorded (page 151) or imported (page 175) from
the specified source sample.
• If, for example, you want reverb to be ON whenever the power is
turned on or a program is initialized, use the following procedure:
1. Create a program that uses reverb.
2. Go to the REGISTER page and select Program as the
Regist Type.
3. Select the program created in step 1 as the Source
Program, and set the Regist Source EFFECT parame-
ter to SourcePgm.
4. Execute the Register command.
• The registered settings are retained even when the power is turned
off.
• When new settings are registered the previously registered settings
are erased and overwritten.
[Operation]
1. Select the Regist Type (page 215).
2. Make other settings as required.
3. Press Knob 1 (EXEC) or Knob 5 (EXEC&CONT), and the register
confirmation display will appear. Press Knob 5 (YES) to execute
the register operation.
• If Knob 1 (EXEC) is used to execute the command, the display
previous to the command menu will be recalled after execution
has finished. If Knob 5 (EXEC&CONT) is used to execute the
command, the register display will be retained so you can con-
tinue and perform further register operations.
Knob 1
[ Turn] Cursor
Positions the cursor.
[ Press] EXEC
Press this knob to call the register confirmation display.
Press Knob 5 (YES) to actually execute the register oper-
ation.
Cursor w
(when the FreezeType is SampleBank&LpMode
→ Sam-
ples, SampleBank → Samples, and LpMode → Samples)
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn
action
Cursor —
From
SampleBank
Loop Mode —
Press
action
EXEC — — — EXEC&CONT
w
Cursor
Cursor q
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn
action
Cursor Regist Type — — —
Press
action
EXEC — — — EXEC&CONT
q
Cursor