Operation Manual

About the COMMANDS
● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● A5000/A4000 • Chapter 9 COMMAND 219
Knob 3
[ Turn] Plus Side Gain
Specifies an amount of amplification (in percent) to be
applied to only the plus side (the section of the waveform
above the center “0” line) of the selected sample’s wave-
form. A setting of “100%” normalizes only the plus side of
the waveform. Settings higher than “100%” may produce
clipping.
[Range] 0% — 400%
Knob 5
[ Turn] Minus Side Gain
Specifies an amount of amplification (in percent) to be
applied to only the minus side (the section of the wave-
form below the center “0” line) of the selected sample’s
waveform. A setting of “100%” normalizes only the minus
side of the waveform. Settings higher than “100%” may
produce clipping.
[Range] 0% — 400%
[ Press] EXEC&CONT
Press this knob to call the normalize confirmation display.
Press Knob 5 (YES) to actually execute the normalize
operation.
Knob 1
Same function as Cursor q (page 218).
Knob 2
[ Turn] Fade Type
Specifies the type of fade to be created: fade in or fade
out.
[Range] FadeIn, FadeOut
• FadeIn ... Produces a fade-in.
• FadeOut ... Produces a fade-out.
Knob 3
[ Turn] Curve
This setting selects the curve type for the fade in/out.
Three types are available, as illustrated below.
[Range] -exponent, linear, +exponent
Plus Side Gain set to 50%
100%
50%
50%
100%
0%
Plus Side Gain set to 100%
(standard normalize)
100%
100%
0%
Plus Side Gain set to 200%
100%
50%
50%
100%
0%
Minus Side Gain set to 100%
(standard normalize)
100%
100%
0%
Minus Side Gain set to 50%
100%
50%
50%
100%
0%
Minus Side Gain set to 200%
100%
50%
50%
100%
0%
Cursor w (when the Process Type is Fade)
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn
action
Cursor Fade Type Curve Length Length %
Press
action
EXEC ———EXEC&CONT
w
Cursor
Fade In
Start address
Length
Fade Out
End address
Length
Level
-exponent
Fade-In Curves
Time
Level
linear
Time
Level
+exponent
Time
Level
-exponent
Fade-Out Curves
Time
Level
linear
Time
Level
+exponent
Time