Operation Manual

About the COMMANDS
● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● A5000/A4000 • Chapter 9 COMMAND 227
Knob 3
[ Turn] From SampleBank
Specifies the source sample bank from which samples
are to be moved. This parameter can be used when the
Move Type is set to SampleBank→Program, Sample-
Bank(Freeze)→Program, or SampleBank→SampleBank.
[Range] All sample banks in memory.
Knob 4
[ Turn] To Program
Specifies the destination program to which samples are
to be moved. This parameter can be used when the Move
Type is set to SampleBank→Program or Sample-
Bank(Freeze)→Program.
[Range] 001 — 128
Knob 5
[ Turn] To SampleBank
Specifies the destination sample bank to which samples
are to be moved. This parameter can be used when the
Move Type is set to Program→SampleBank, Pro-
gram(Freeze)→SampleBank, or Sample-
Bank→SampleBank.
[Range] All sample banks in memory.
[ Press] EXEC&CONT
Press this knob to call the move confirmation display.
Press Knob 5 (YES) to actually execute the move opera-
tion.
CREATE OSC
[COMMAND/EXIT] Button → Knob 1 to highlight display line 4
→ Press Knob 3
Creates 7 different basic oscillator waveforms: sine wave, saw
up, triangle, square, pulse 1, pulse 2, pulse 3.
• If a sample with the same name already exists in memory, the exist-
ing sample is used.
[Operation]
1. Press Knob 1 (EXEC) or Knob 5 (EXEC&CONT), and the create
oscillator confirmation display will appear. Press Knob 5 (YES) to
execute the create oscillator operation.
• If Knob 1 (EXEC) is used to execute the command, the display pre-
vious to the command menu will be recalled after execution has fin-
ished. If Knob 5 (EXEC&CONT) is used to execute the command,
the create oscillator display will be retained so you can continue
and perform further create oscillator operations.
Knob 1
[ Press] EXEC
Press this knob to call the create oscillator confirmation
display. Press Knob 5 (YES) to actually execute the cre-
ate oscillator operation.
Knob 5
[ Press] EXEC&CONT
Press this knob to call the create oscillator confirmation
display. Press Knob 5 (YES) to actually execute the cre-
ate oscillator operation.
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn
action
—————
Press
action
EXEC ———EXEC&CONT